Hello
i wanna build a rectifier board for my DIY dac, since i think this is the better route with better parts than buying chinese ones..
did people around here test different stuff and know what sounds or is best?
i have a "audiophile" thel power supply here which seems to have 12x 3300uF for smoothing and dedicated diodes, is this the way to go?
is just LOW ESR important?
when designing a device you should first know and state what are your need , and then you draw and build
so what are your needs for that DAC ??
snubber value are from transformer datasheet and measurements not from stuff read here or there
it may not seems but DIY is an serious affair
.